1 / 1
Ender 5 plus bed alignment blocks
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ender 5 plus comes without independent stepper motor drivers for the two Z motors, which means that when powered down they easily move a few steps and the bed will tilt a bit and cause an inconsistent first layer.
One or two of these blocks under the bearings on each side of the bed can be used to easily make sure that it is held in level.
How to use: Power on and home the printer, move the bed height approximately so the blocks fit, then fine-tune height on both sides by holding the coupler connecting the motor to the Z screw and rotating it so it skips a step at a time. Finally home once more.