Liquid Soap Dispenser and Sponge Holder

Hello Makers!

Today I decided to publish one of my very useful design ideas for lovers of cooking, but above all kitchen cleaning. A beautiful liquid soap dispenser with a built-in sponge stand!

As an external texture, I decided to use the one already used in the cotton swab and make-up remover pad dispenser, which was an unexpected success for me (You can see that project on my Makerworld profile by clicking here).

To then facilitate the removal of the water in the sponge stand, I decided to study a sled grill that can be removed easily! (Be careful, it is very flexible and delicate).

The thread of the liquid soap holder is designed to be compatible with pumps which have dimensions of 28 mm.

It is very easy to print and only takes just over 7 hours to have the finished product in hand. I decided to use Azurefilm Matte HS Mint as a color reference for this project, which you can purchase here.

printings tips!

For printing I suggest you faithfully maintain the settings that are already present in the file, especially in terms of printing speed and supports. Especially for the supports, I made sure that they could be removed easily, without impacting the quality of the suspended parts. Once the print is finished, I suggest waiting at least 30 minutes before removing the piece.

Don't worry about the support at the entrance to the grille and at the final stop point, because with a small screwdriver it is very simple to remove them. Just be careful that there are no small pieces of plastic from the support left in those places, otherwise the grill will not fit in the slide.

I really hope you like this model, and THANKS to everyone who has supported me so far!