Under desk drawer, 7"x7"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small 7"x7" drawer to go under your desk, 1.5" deep. To assemble, bend the runners apart slightly to fit the…
- Ocena
- 4,667 / 5
- Polubienia
- 14
- Pobrania
- 172
- Wydruki
- 3
- Wyświetlenia
- 718
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
A small 7"x7" drawer to go under your desk, 1.5" deep.
To assemble, bend the runners apart slightly to fit the trapezoid shaped stoppers on the drawer into the groove and hold together while you insert the four screws. I used masking tape to hold everything in place while I installed it.
If you've got everything together correctly after installation the drawer should slide smoothly out and stop itself from completely sliding out.
Print Settings
Printer Brand:
Anycubic
Printer:
All-metal Mega
No
Supports:
No
0.2
Infill:
25%
Filament:
TECBEARS PLA Grey
Notes:
The model has the internal dimensions of the drawer at 7x7x1.5 inches, my print bed wasn't quite large enough at 210x210x205 millimeters to fit the whole thing so I had to scale both parts down to 90%, no big deal.
As this part does have a large footprint I experienced some trouble with warping. The warp resulted in a small lip on the front of the print as seen in the pictures, it still functions just fine.For the runners I waited until the circular screw holes had been finished and used masking tape to hold the four corners down while it continued with the rest of the print. For the drawer itself I used a gluestick on the bed before printing.
Category: Organization