1 / 4
Drift Wheels and tire combined and HEX for MJX Hyper Go 16th scale — zdjęcie 1
1 / 4

Drift Wheels and tire combined and HEX for MJX Hyper Go 16th scale

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Drift wheels with tire and hex MJX Hyper Go H16H H16E H16P 16207 16208 16209 16210 and similar platforms (like Mew4)

Ocena
0 / 5
Polubienia
20
Pobrania
193
Wydruki
0
Wyświetlenia
926
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

Drift wheels and tire combined, its a very simple design, not made for looks, but to be functional, balanced and easy to print. 

Dimensions:

Wheel+tire diameter - 70mm - smaller than the standard 80mm, for better throttle control and lower center of gravity.

Width - 36mm - smaller than standard, to be lightweight

Weight - If printed as i did, around 50g each

dogbone screw diameter- 4mm

I designed some 12mm HEX , 5mm shaft.

Recommended print settings:

0.2 mm, print the wheel on the other side on the plate.

TPU material,it has some flexibility, but the design is rigid enough

6 Layers, 0% infill - any infill pattern i tried it will make the wheel unbalanced, the pattern is not perfectly omogen everywhere. so i decided just to make more parameters, and 0% infill, so the wheel is lightweight, has some flexibility, but also keeping rigidity and balance.

The HEX i prinded out of TPU also, but you can print it PLA too, the drift wheels will not have to carry too much force, they are made to slip.

Notes: Use elephant's foot compensation or dont worry about it, it will be straight after the first drifts.

 

Use supports, i used snug, it will only be needed in the central part. 

Enjoy, i hope you have fun. I included the f3d file, for Fusion 360 if you want to modify it.

 

Update: Rounded edges of the tire and the tire itself, the old design still had too much grip and it was too sensitive to any surface deformation. I will update the photos when i print them.