Drift Wheels and tire combined and HEX for MJX Hyper Go 16th scale
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drift wheels with tire and hex MJX Hyper Go H16H H16E H16P 16207 16208 16209 16210 and similar platforms (like Mew4)
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 192
- Makes
- 0
- Views
- 925
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
Drift wheels and tire combined, its a very simple design, not made for looks, but to be functional, balanced and easy to print.
Dimensions:
Wheel+tire diameter - 70mm - smaller than the standard 80mm, for better throttle control and lower center of gravity.
Width - 36mm - smaller than standard, to be lightweight
Weight - If printed as i did, around 50g each
dogbone screw diameter- 4mm
I designed some 12mm HEX , 5mm shaft.
Recommended print settings:
0.2 mm, print the wheel on the other side on the plate.
TPU material,it has some flexibility, but the design is rigid enough
6 Layers, 0% infill - any infill pattern i tried it will make the wheel unbalanced, the pattern is not perfectly omogen everywhere. so i decided just to make more parameters, and 0% infill, so the wheel is lightweight, has some flexibility, but also keeping rigidity and balance.
The HEX i prinded out of TPU also, but you can print it PLA too, the drift wheels will not have to carry too much force, they are made to slip.
Notes: Use elephant's foot compensation or dont worry about it, it will be straight after the first drifts.
Use supports, i used snug, it will only be needed in the central part.
Enjoy, i hope you have fun. I included the f3d file, for Fusion 360 if you want to modify it.
Update: Rounded edges of the tire and the tire itself, the old design still had too much grip and it was too sensitive to any surface deformation. I will update the photos when i print them.
