1 / 3
Right Angle Power End Cap for Scosche BaseLynx
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replacement end cap allows you to use a right-angle power cord with your Scosche BaseLynx system
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This replacement end cap allows you to use a right-angle C7 power cord with your Scosche BaseLynx modular charging system.
Design features
- Same styling as the original part, but slightly wider to accommodate the right angle power cord.
Printing instructions
- Print one end cap in an appropriate material, and two pins in TPU.
- Print the .stl files as-oriented.
- Note: The pins are designed to be printed with TPU for the correct fit.
Installation instructions
- Screw the pins into the end cap until the threads are fully below the top surface (as far as you can).
- Install the end cap onto your first BaseLynx module as with the original.
- Plug the power cord in.
- To remove, gently pull the end cap off to disconnect the cord.
Safety notes
- This model is not designed to come in contact with any electricity.
- Make sure the cord is fully engaged and properly aligned.
Notes
- I designed this model in OpenSCAD and it's fully parameterized. If you'd like a simple modification (i.e., cord cutout size, etc.), send me a message and I'll see what I can do.