Eufy 2k indoor camera outdoor cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
cover for Eufy indoor camera to allow outdoor use. Save some money!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 205
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
Eufy 2k indoor camera outdoor cover.
Printed in PETG 30% infill with several outer layers for top bottom and sides. But should print well with many setting. Try it and see.
Rear cover and visor has 2mm screw holes that work well with plastic post screws from electronics but can be drilled to fit what you have.
I ended up clamping the visor down and gluing it to the main body as it tended to kick up at the back when screwed on. You could probably just glue it if you don't want to use screws for the visor. CA glue(superglue) works well.
1.75mm O ring groove at the front. I made o rings out of TPU glued the ends with CA to fit. I greased the o rings lightly with Vaseline(petroleum jelly)
Case has held up outdoors for more than 2 years. It is mounted under a small eve/lip. Probably not the best design for fully exposed outdoor use. somewhere semi dry works well. However it seals quite well with some light silicone between the back and front housing.
you do need to disassemble for USB installation and SD card removal( I haven't needed to since I installed them) I made USB pigtails to make USB installation easy using connectors pictured with just the 5v and Ground soldered up. But get creative sure you can make a USB cable work in a pinch.
Enjoy saving money as Eufy outdoor units are expensive!
Please excuse the dusty camera in photos. This one has been waiting on a shelf to be installed for more then a year.