Canning Jar Lid Dispensers - Large and Small
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organization/dispensers for reusable canning jar lids.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 206
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
These models are designed to hold Ball brand reusable canning jar dispensers, both small and large sizes. They can stack up to 6 lids in each dispenser. A lip at the bottom helps to hold lids in while moving or using the dispensers.
Prints shouldn't need supports, but overhangs on the wraparound upper portion are approximately 55 degrees on the larger model and 50 degrees on the smaller model. Make sure you have adequate cooling for a clean print.
An Autodesk Fusion model has been included with favorite parameters to adjust the size of the model to fit other lids or use cases.
Note: The chamfer distance for the bottom corners of the overhang will require adjustment to precisely reach the lower corners. (I tweaked my distance values to at least 3 decimal places.) This ensures the fillets will work properly.