1 / 11
QST Express Caliper Battery Mod - Manufactured Holder — zdjęcie 1
1 / 11

QST Express Caliper Battery Mod - Manufactured Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of https://www.printables.com/model/502985-qst-express-caliper-battery-mod

Ocena
0 / 5
Polubienia
5
Pobrania
19
Wydruki
0
Wyświetlenia
312
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix of https://www.printables.com/model/502985-qst-express-caliper-battery-mod by adding a cut away tab, and space for a Manufactured AA Holder

https://www.amazon.com/dp/B07QMQ5F21?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Created a DEEP wall mount for this AA battery mod, see

https://www.printables.com/model/1042553-holder-for-vernier-caliper-with-thumb-wheel-no-sup

Instructions (see pictures)

Drill a hole in manufactured AA holder, to bring red wire into the groove of the printed STL 

Feed wires as shown into the printed STL

Glue the holder to the STL with two part epoxy, wait to cure

There are two holes to secure the end of each wire, they print undersize and need to be opened a little

Route wires as show with the end of the wire in each hole

The ball of solder will be the point of contact, add some glue where wires make the 90 degree turn up (this and the wire tip in a hole should secure the wires)

The two screws to mount the battery holder to the caliper are; M1.6 x 8mm