1 / 11
QST Express Caliper Battery Mod - Manufactured Holder — image 1
1 / 11

QST Express Caliper Battery Mod - Manufactured Holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of https://www.printables.com/model/502985-qst-express-caliper-battery-mod

Rating
0 / 5
Likes
5
Downloads
19
Makes
0
Views
309
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Remix of https://www.printables.com/model/502985-qst-express-caliper-battery-mod by adding a cut away tab, and space for a Manufactured AA Holder

https://www.amazon.com/dp/B07QMQ5F21?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Created a DEEP wall mount for this AA battery mod, see

https://www.printables.com/model/1042553-holder-for-vernier-caliper-with-thumb-wheel-no-sup

Instructions (see pictures)

Drill a hole in manufactured AA holder, to bring red wire into the groove of the printed STL 

Feed wires as shown into the printed STL

Glue the holder to the STL with two part epoxy, wait to cure

There are two holes to secure the end of each wire, they print undersize and need to be opened a little

Route wires as show with the end of the wire in each hole

The ball of solder will be the point of contact, add some glue where wires make the 90 degree turn up (this and the wire tip in a hole should secure the wires)

The two screws to mount the battery holder to the caliper are; M1.6 x 8mm