1 / 10
Gas Struts for Prusa XL Enclosure Lid
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parts needed to add a gas strut/spring to the Prusa XL Enclosure lid.
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 58
- Wydruki
- 5
- Wyświetlenia
- 700
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 5) (Komentarze: 17)Remiksy (0)Kolekcje (82)Powiązane
Add gas struts/springs to the Prusa XL Exclosure Lid to make opening and closing it easier. This also allows you to put the Prusa XL Enclosure on a rack that has a shelf right above. Adjustable for two open heights.
Parts
- 2x Gas Struts (30-40N, 6in). I prefer the gentler feel of the 30N ones, but I've tested both. 20N is not strong enough.
- 4x M4x12
- 4x M4x8r (you should have extras from the enclosure build)
- 10x M3x10 (you might have extras from different Prusa kits)
- 1x Left and Right Frame Printed Parts
- 2x Lid Printed Parts
Printing Instructions
Print with PETG, 3 walls and 20% infill. PLA will soften in the enclosure.
Installation Instructions
- Attach the lid printed parts to the lid with the M4x12 screws
- Attach the long gas strut connectors to the lid printed parts with M4x8r screws such that the ball joints are facing the side of the printer (not the center).
- Attach the round gas strut connectors to the frame printed parts with M3x10 screws.
- Attach the frame printed parts to the Prusa Enclosure frame with M3x10 screws.
- Holes with dots: lid opens as high as possible.
- Holes without dots: lid opens level with the top rear of the enclosure.
- Press the gas struts onto their ball joints.
- I removed the magnets on the lid since the gas struts hold the door closed on their own and the magnets just add unnecessary extra pull force when opening.