1 / 10
Gas Struts for Prusa XL Enclosure Lid
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Parts needed to add a gas strut/spring to the Prusa XL Enclosure lid.
- Rating
- 5 / 5
- Likes
- 40
- Downloads
- 58
- Makes
- 5
- Views
- 701
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Add gas struts/springs to the Prusa XL Exclosure Lid to make opening and closing it easier. This also allows you to put the Prusa XL Enclosure on a rack that has a shelf right above. Adjustable for two open heights.
Parts
- 2x Gas Struts (30-40N, 6in). I prefer the gentler feel of the 30N ones, but I've tested both. 20N is not strong enough.
- 4x M4x12
- 4x M4x8r (you should have extras from the enclosure build)
- 10x M3x10 (you might have extras from different Prusa kits)
- 1x Left and Right Frame Printed Parts
- 2x Lid Printed Parts
Printing Instructions
Print with PETG, 3 walls and 20% infill. PLA will soften in the enclosure.
Installation Instructions
- Attach the lid printed parts to the lid with the M4x12 screws
- Attach the long gas strut connectors to the lid printed parts with M4x8r screws such that the ball joints are facing the side of the printer (not the center).
- Attach the round gas strut connectors to the frame printed parts with M3x10 screws.
- Attach the frame printed parts to the Prusa Enclosure frame with M3x10 screws.
- Holes with dots: lid opens as high as possible.
- Holes without dots: lid opens level with the top rear of the enclosure.
- Press the gas struts onto their ball joints.
- I removed the magnets on the lid since the gas struts hold the door closed on their own and the magnets just add unnecessary extra pull force when opening.