FlashForge Adventurer 5M Side Mount Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flashforge Adventurer 5M (AD5M) Voronoi Side Mount Spool Holder. The most direct filament path there is.
- Ocena
- 5 / 5
- Polubienia
- 367
- Pobrania
- 2901
- Wydruki
- 13
- Wyświetlenia
- 11 365
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Overview
A re-imagined side mounted spool holder for the Flashforge Adventurer 5M. This design fits over your existing enclosure piece “D1”. A 4mm x 10mm bolt might be needed to replace the existing bolt in the guard plate, although I was able to use the stock one. There are 2 spots to insert short runs of PTFE tube to lower the friction between the spool and the holder. Designed to offer the most direct path to load your filament as possible, complete with a voronoi look to finish it off. The non-enclosure version is untested as it was made per request.
Printing
It is more than possible to print this without any supports, and I would recommend it. Although you might need to clean the voronoi holes up a bit afterwards. If you use supports, I suggest trees on the build plate only. Good luck getting them all out.
Nozzle: .4
Filament: PLA/PETG
Layer Height: .2
Supports: No
Bedplate Adhesion: Yes. Brim.
Take a look at my custom Adventurer 5M Toolhead Shrouds or any of my other Adventurer 5M Add-ons while you are here.
Like My Work?
❤ a few of my models
or
Edits:
11/22/25 | Addressed corner on non enclosure version.