Shelf Support Tab
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed a way to support an undershelf board.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had been trying to organize my power tools and am using a board under a shelf to mount different printed items (power tool holders, battery mounts, etc) but to get the board in, I had to trim it down, which led to problems when trying to pull batteries off (it would fall down). So I made these tabs to extend the support for the board to rest on. Now it has enough support to keep from sliding too far either way to fall and can be turned to allow the removal of the board if I want to add more mounts. I am using #8 hardware (bolt, nuts, washers from home depot)
Filament: PETG HF (black)
0.20mm Strength @BBL X1C
Sparse infill density: 50
Sparse infill pattern: Adaptive Cubic