Side - Bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Scoot your Trash into this Side Bin - Presented by SMACKMAX
- Ocena
- 5 / 5
- Polubienia
- 382
- Pobrania
- 633
- Wydruki
- 4
- Wyświetlenia
- 5195
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Consider following me on Instagram (@SMACKMAX_). I try to post all of my projects to build a portfolio of my projects. https://www.instagram.com/smackmax_/
22-10-2024: Small update, one bolt hole was missing in the under side of Tub file, now fixed! (should still work without, if anyone already printed it)
21-10-2024: Small update: Orientation & Assembly Update: Orientation: Print everything in the orientation of the final assembly:
Assembly: Insert Nut into Gripper and Magnets 4x (D5x2 mm) - Install Middle Ring Onto Tub (4x M3x10 Hex) - Install Magnets onto Ring (3x (D5x 2 mm) - Install bottom to Tub 4x (M3x10 mm) - slide in the assembly (tolerances are a bit tight, but after a couple used it should be right on point for a smooth operation.
*works best on sqaure ish tables, but as pictured i also use mine on round Table.
*The dovetail fit might seem tight, but after testing multiple versions, this works best after a couple of uses. If that does not work you can lighty sand the dovetail.
I have alot of small trash that i scoot up with my hand, losing a bit on the floor everytime. This should solve this very Niche issue that i have haha. Fits desk Thickness from 10-40 mm Installation: Snug bolt to Table pull bin Print orientation: See image in post Magnets: 8 pc (D5x2 mm) 7 pcs M3 (Hex) 10 mm