ENDER 3 NG v1.2 - Stealthburner Toolhead Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use the Stealthburner toolhead on your E3NG!
- Ocena
- 5 / 5
- Polubienia
- 120
- Pobrania
- 402
- Wydruki
- 1
- Wyświetlenia
- 3713
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I completely remodelled the entire toolhead base to perfectly fit a Stealthburner toolhead.
This mount was designed to take up as little space as possible and e.g. still allow the use of the Z-Endstop / Sexbolt (a simple adapter plate would waste too much space, so the nozzle could not reach the Sexbolt at the back of the print bed). I attached a photo where the toolhead is at Y-min position (approx. 2mm behind the sexbolt).
This design has 2 built-in supports that must be removed. Print on the side where the switch will be installed (see Slicer Screenshot). Use same print settings as for all other E3NG parts.
Hardware required:
- 4 * VORON heat inserts for the front (M3 x 5 x 4)
- 4 * E3NG heat inserts for the back (M3 x 4 x 4.5)