ENDER 3 NG v1.2 - Stealthburner Toolhead Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use the Stealthburner toolhead on your E3NG!
- Rating
- 5 / 5
- Likes
- 120
- Downloads
- 402
- Makes
- 1
- Views
- 3,713
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I completely remodelled the entire toolhead base to perfectly fit a Stealthburner toolhead.
This mount was designed to take up as little space as possible and e.g. still allow the use of the Z-Endstop / Sexbolt (a simple adapter plate would waste too much space, so the nozzle could not reach the Sexbolt at the back of the print bed). I attached a photo where the toolhead is at Y-min position (approx. 2mm behind the sexbolt).
This design has 2 built-in supports that must be removed. Print on the side where the switch will be installed (see Slicer Screenshot). Use same print settings as for all other E3NG parts.
Hardware required:
- 4 * VORON heat inserts for the front (M3 x 5 x 4)
- 4 * E3NG heat inserts for the back (M3 x 4 x 4.5)