Rollei 35AF 43mm Filter Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A common complaint about the Rollei was the lack of filter thread, I so designed one.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 178
- Wydruki
- 1
- Wyświetlenia
- 1162
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
I've designed a 43mm filter thread for the rollei. It's the largest thread I could make without interfering with the light sensor which is very close to the lens. It's push fit and twist to lock it in between the ribs of the lens.
Take care lining up the thread rings with the lens as it's a tight fit and they might snap if you try to push them into the ribs.
Printed in PLA with supports with the threads facing up to the sky or the supports will create misalignment. (I'm sure any material would be fine)
The supports are important as without them there's major failure. My exact settings were
Tree Supports
Style: Tree Slim
Threashold Angle: 17
Remove Small Overhangs: Disabled
Do Not Sell.