Pathfinder Action Tracker - with magnetic slides
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Action tracker for Pathfinder 2e. Slide the magnetic slides to keep track. Inverted & blank versions included.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 495
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Shonk created a fantastic action tracker for Pathfinder 2. This remix updates the model to add magnets (I love magnets!) so that the sliders will magnetically snap into their up or down position. Updated all of Shonk's versions; extruded, inset, and blank
MATERIALS:
Designed to use 8mm x 1mm disc magnets. I got them from Apex Magnets but they can also be found on Amazon:
Use regular super glue (not the gel super glue). The gel super glue will not flow very easily into the glue channels
ASSEMBLY:
Note 1: The magnets in the baseplate and the sliders need to repel each other (not attract). See picture for reference.
Note 2: It is really easy to accidentally glue magnets in the wrong direction. Recommend using some magnet insertion tools to help guarantee that you insert all the magnets in the correct orientation. You can easily create some magnet insertion tools with a couple of spare magnets and some tape (See picture for reference). Or you can 3D print one of the magnet insertion tools below:
- https://www.printables.com/model/1049343-magnet-installation-tool
- https://www.printables.com/model/975729-magnet-insertion-tool-v1
Glue the magnets into the baseplate and the sliders. Make sure the baseplate and slider magnets repel each other (See picture for reference)
Insert the sliders into the baseplate paying attention to the orientation depicted on the baseplate
Place the top plate on. Recommend holding the top plate with tape or rubber bands to make sure it is held down tight. Put a drop of super glue into each of the glue channels on the bottom side of the baseplate. The glue should flow into the bottom of the glue channels. If it doesn't you can use a toothpick to help it flow into the glue channel.