4xAAA Battery Holder with Integrated Spring (narrow version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model is inspired by https://www.thingiverse.com/thing:456900. It is made to be 7.4 mm narrower than the…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 58
- Wydruki
- 1
- Wyświetlenia
- 600
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This model is inspired by https://www.thingiverse.com/thing:456900. It is made to be 7.4 mm narrower than the original, saving precious space in your models.
That is achieved by thinning the walls between the batteries down to 1 mm (rather than the original 3.5 mm). Therefore, the springs had to be completely remodeled.
It also has only 4 M2 mm screw holes and additional cable management holes at the anodes side.
Recommended Extrusion Width: 0.56 mm
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
0.20
Infill:
15%
Notes:
Extrusion Width: 0.56 mm
Material: PET or ABS
Post-Printing
Use thin wires (up to 1.3 mm in diameter) to connect the cathodes and anodes of the adjacent batteries, using the integrated cable management ridges and holes. Make a few loops around each contact, rather than welding, because you have to be really skillful not to melt the plastic in the process.
Category: Electronics