QIDI Plus4 Tensioner (freecad)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Qidi Plus4 Belt tensioner from Jerky_FPV remade in freecad. (Sources included)
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 798
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE:
- RC2: Smaller diameter cylinder so it actually fits through the hole… Smaller length cylinder so you can install it without tension applied to the belts.
I only had 30mm long screws at home so I started to design a variant that fits the shorter screws. The picture attached shows the crucial measurement using a 30mm screw. I suggest you to drive in the screw from the front for the first time so the thread will be cut aligned with the nut.
This was basically a freecad practice for me. I did not test it yet, because I'm new to the core xy world so I want to get some knowledge before messing with the belts. I've measured the original stls so critical dimensions should match. Any feedback is appreciated.
Freecad source files are included so you can make your own part fitting your needs.
Freecad 1.0.0RC2 and Fasteners workbench 0.5.29 versions were used, so I think these are the lowest versions you can work with it. Though I'm not sure you need the fasteners workbench to open it.
Print settings I used:
- Material: eSun pa6cf
- Walls: 3
- Infill: 20% gyroid
- Layer height:
- First layer: 0.2mm
- Other layers: 0.16mm
- Top shell layers: 5
- Bottom shell layers: 3