Lifetime Kayak Seat Strap Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have a Lifetime Tamarack 100. I was adjusting my seat on the river and this clip popped off, never to be seen again.…
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 54
- Wydruki
- 1
- Wyświetlenia
- 168
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
I have a Lifetime Tamarack 100. I was adjusting my seat on the river and this clip popped off, never to be seen again. I found the model by Hparsonst and gave it a try. It was a little thinner than my original and didn't clip on securely.
I ended up modeling my own from scratch. I am posting it as a remix because I was inspired by Hparsonst's model and wanted to give people an option if one or the other of ours isn't quite right for your kayak model.
I printed mine in PETG to give it a little more life in the heat and water. I imagine PLA would be plenty strong, though.
Support is only needed for the bar going across. I used lines support at 20% with no interface and a 0.2 mm join distance, which worked out nicely.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 Max
No
Supports:
Yes
0.2
Infill:
75% Gyroid
Notes:
Support is only needed for the bar going across. I used lines support at 20% with no interface and a 0.2 mm join distance.
Category: Sport & Outdoors