Petzl Vertex helmet basic mounting plate (also for customisation)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple baseplate for mounting stuff to your Petzl Vertex helmet using the existing slots. Including DXF & Fusion360
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 676
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
I was looking for a solution for mounting stuff to my new Petzl Vertex Vent helmet, in particular it was the battery pack of my headlamp. So i found KIL0's design, which seemed quite sturdy, i printed it and was very satisfied. Unfortunately he did not provide the CAD files, so I redraw the interface surface to his adaptor brackets and extruded an even surface for a velcro strap, because my battery already had a velcro strap.
You need the following hardware
- 4x M3 nuts
- 4x M3x12 counter sunk hex screws
Instructions
- Print both adapters and the body
- Insert nuts into the body
- Screw brackets to body
Tipps for your own design
- The brackets take up approx. 5mm of the screws' length
- An ordinary M3 nut is 2.4mm thick
- You can use my reverse engineered drawing by importing the DXF file or use my Fusion project as a base for your design.