Petzl Vertex helmet basic mounting plate (also for customisation)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple baseplate for mounting stuff to your Petzl Vertex helmet using the existing slots. Including DXF & Fusion360
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 105
- Makes
- 0
- Views
- 676
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
I was looking for a solution for mounting stuff to my new Petzl Vertex Vent helmet, in particular it was the battery pack of my headlamp. So i found KIL0's design, which seemed quite sturdy, i printed it and was very satisfied. Unfortunately he did not provide the CAD files, so I redraw the interface surface to his adaptor brackets and extruded an even surface for a velcro strap, because my battery already had a velcro strap.
You need the following hardware
- 4x M3 nuts
- 4x M3x12 counter sunk hex screws
Instructions
- Print both adapters and the body
- Insert nuts into the body
- Screw brackets to body
Tipps for your own design
- The brackets take up approx. 5mm of the screws' length
- An ordinary M3 nut is 2.4mm thick
- You can use my reverse engineered drawing by importing the DXF file or use my Fusion project as a base for your design.