1 / 2
Phanteks T30 + Exhaust fan duct clip — zdjęcie 1
1 / 2

Phanteks T30 + Exhaust fan duct clip

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connect Phanteks T30 fans to fan ducts without the use of screws.

Ocena
0 / 5
Polubienia
5
Pobrania
81
Wydruki
0
Wyświetlenia
748
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wanted to attach the following fan duct to my FormD T1 2.1 case with Phanteks T30 exhaust fans and didn't want to use screws. I did slice the top of the fan duct to be 8mm tall so it sits against my top panel. 


https://www.printables.com/model/892898-formd-t1-21-120mm-noctua-nf-a12x25-pwm-fan-duct

This clip snaps on easily and snug. It might fit other fans as well, but haven't tested it as I only have these. As long as the fan duct is 4mm, this will fit without modification. 

I printed it in ABS. Depending on your temps, PLA might soften.

Add the clips in an X-pattern

Tagi