Phanteks T30 + Exhaust fan duct clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Connect Phanteks T30 fans to fan ducts without the use of screws.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 81
- Makes
- 0
- Views
- 748
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted to attach the following fan duct to my FormD T1 2.1 case with Phanteks T30 exhaust fans and didn't want to use screws. I did slice the top of the fan duct to be 8mm tall so it sits against my top panel.
https://www.printables.com/model/892898-formd-t1-21-120mm-noctua-nf-a12x25-pwm-fan-duct
This clip snaps on easily and snug. It might fit other fans as well, but haven't tested it as I only have these. As long as the fan duct is 4mm, this will fit without modification.
I printed it in ABS. Depending on your temps, PLA might soften.
Add the clips in an X-pattern