1 / 3
Noctua NA-FD1 Fan Duct for Asrock Deskmini X600 + X300 — zdjęcie 1
1 / 3

Noctua NA-FD1 Fan Duct for Asrock Deskmini X600 + X300

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bridges the gap between the fan and perforated case panel in order to enable the cooler to draw in fresh air

Ocena
5 / 5
Polubienia
7
Pobrania
99
Wydruki
1
Wyświetlenia
1394
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

I remixed this model from the original Noctua design to fit into my Asrock Deskmini X600 with the Noctua NH-L9a-AM5 fan.

It should be suitable for the AMD AM4 and L9i (Intel) version and Deskmini X300 as well.

You just need 4x 20mm M3 screws to fix the 3D printed fan duct and the original fan into the original holes.

I printed it with tree supports but it should probably also work without supports.

Print orientation as shown in the image. 

 

Here is the use case from the original design description:

The NA-FD1 fan duct kit makes it possible to significantly improve the performance of Noctua NH-L9i and NH-L9a series CPU coolers in Small Form Factor (SFF) environments where there is a gap of 5mm or more (up to 45mm) between the cooler and a perforated top or side panel. Bridging this gap, the duct prevents the cooler from taking in hot air from the interior and enables it to draw in fresh air from the outside through the perforated panel, which can, depending on the setup, improve CPU temperatures by as much as 5°C or more.

Tagi