1 / 1
Padme Pistol w/ Weighted Grip and Holster — zdjęcie 1

Padme Pistol w/ Weighted Grip and Holster

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A prop to use with your Padme costume!

Ocena
4,5 / 5
Polubienia
15
Pobrania
114
Wydruki
2
Wyświetlenia
692
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Props
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wanted to make the gun feel a bit more weighted and also cosplay-usable. The blaster holster should fit most belts, and should be printed on its most-flat side to allow the clip to flex without breaking. This should have supports **enabled**.

Layer lines for the clip should be running parallel to the motion!

I used two [20g lead weights](https://www.aliexpress.us/item/3256806406955940.html?channel=twinner) for the grip. If the aliexpress link dies, they're 39mm long and 7.5mm wide. The grip should be printed **without supports**.

The plug was printed in PLA with the tip switching over to TPU. Print this plug at **92%** scale (never at 100%, tolerance is too tight) for easy installation. **No supports.**

Tagi