Padme Pistol w/ Weighted Grip and Holster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A prop to use with your Padme costume!
- Rating
- 4.5 / 5
- Likes
- 15
- Downloads
- 114
- Makes
- 2
- Views
- 697
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted to make the gun feel a bit more weighted and also cosplay-usable. The blaster holster should fit most belts, and should be printed on its most-flat side to allow the clip to flex without breaking. This should have supports **enabled**.
Layer lines for the clip should be running parallel to the motion!
I used two [20g lead weights](https://www.aliexpress.us/item/3256806406955940.html?channel=twinner) for the grip. If the aliexpress link dies, they're 39mm long and 7.5mm wide. The grip should be printed **without supports**.
The plug was printed in PLA with the tip switching over to TPU. Print this plug at **92%** scale (never at 100%, tolerance is too tight) for easy installation. **No supports.**