1 / 4
Ikea Skadis Two Bottle Holder (50 mm/200 ml/Vallejo)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Strong bottle holder for Ikea's Skadis peg system. Holds two bottles of 50 mm diameter (like Vallejo's 200 ml bottles).
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 385
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (30)Powiązane
Strong bottle holder for Ikea's Skadis peg system.
Holds two bottles of 50 mm diameter (like Vallejo's 200 ml bottles).
Uses six pegs for better strength.
How to print:
- Print on the side with supports as shown in the pictures for strength.
- Design is optimized for 0.4 mm nozzle but would work on 0.6 mm.
- Use the 0.2 mm STRUCTURAL preset.
- Tested with infill to 50%.
- Recommended PETG, but PLA should still hold well.
- Pre-supported Prusa Slicer project included, as well as gcode for MK4S and PETG. Supports are easy to remove.