Montessori soda volcano
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An interactive Montessori soda volcano that goes BOOOM!
- Ocena
- 5 / 5
- Polubienia
- 69
- Pobrania
- 128
- Wydruki
- 2
- Wyświetlenia
- 1079
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other 3D Objects for Learning
- Licencja
- Creative Commons — Attribution — Noncommercial
How it works
Close the volcano and place the ground piece on top. At the back of the volcano, there’s a slot for a 9mm silicone tube. Connect this tube to a syringe filled with vinegar. Add some baking soda and a few drops of food coloring to the magma chamber. Push the syringe, and BOOOOOM! Enjoy the eruption!
Printing
All parts print easily without supports. Alongside fully multicolor files (including ash layers), I’ve also provided files with separate ash layers, which can reduce print time by half. After printing, use superglue to attach the ash lines to the volcano.
For best results, I recommend printing with 3 perimeters to ensure the model is fully sealed.
Magnets
Inside the volcano’s walls, there are spaces for 14mm x 2mm magnets. While not necessary, adding them gives a satisfying snap when assembling the two halves.