Garage Door Opener Sensor Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple 3D printed Infrared signal interference screen.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution
Likely a very basic use of the P1S but it is a functional problem that we were able to solve.
Background
Recently upgraded Two (2), side-by-side Garage Door Openers. Also have a garage parking assistant. Long story, short, the parking assistant infrared beam was wreaking havoc with the obstruction sensors of the garage door openers. I tried all the permutations of installation with send / receive directions but could not get reliable open and closing functionality. Finally, identified the culprit.
Solution
A simple 3D printed signal screen. I wanted something that I could mount to the wall and be off the floor, so not to interfere with cleaning. We modeled the design with cardboard cutouts (from Amazon box) and then whipped up a design based on the cardboard machup that worked out perfectly. In a matter of minutes to design and tweak (even included counter-sunk screw holes), followed by an hour+ print, and then a minutes to install, I now have reliable open and close of both garage door opener units with parking assistance without issue!
P1S / Black BambuLabs PLA / Tree Supports