Trekking Pole Rubber Tips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Heyho
Some time ago I designed different tips for my trekking/ hiking sticks. They are not that expensive to buy but since I have a 3D printer I designed my own versions :P
I designed the geometry to be printed without supports or anything and adapted the form to my leki sticks. But I think they are also usable for other brands.
Print Instructions:
Use some rubber like filament like TPU/ TPE. I tested them in different hardnesses and even with TPU-CF. All worked gr8.
Part Explanation:
During the design phase ofc. I was inspired by existing versions out there. But here are my final versions.
- Crown → My favourite every terrain Version.
- Spike → Good for rougher/ harder surfaces to get a good coordination and have a small footprint.
- Rough_ Angle → If u prefer rubber tips with an angle. Rough pattern for rough/ soft terrain.
- Bigfoot → Good for soft ground.
- Bigfoot_Slim → Same as bigfoot but a little slimmer optix.
- Urban → Not as good grip as the others but a big surface for a little dampening I guess.
Assembly:
Simply put them onto the tip of the stick and stomp them to the ground with a little force. That should do the job!
Have fun!