1 / 6
Atomic Fan-less cover for SV08 with clips & wide nozzle visibility [Eddy compatible] — zdjęcie 1
1 / 6

Atomic Fan-less cover for SV08 with clips & wide nozzle visibility [Eddy compatible]

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cover for independent fan holder

Ocena
0 / 5
Polubienia
31
Pobrania
205
Wydruki
0
Wyświetlenia
1249
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a cover fully built from scratch. It does not hold the fan, and instead the fan is separated. See Independent fan holder.

Why does it exist:

  • Clips ON - won't fall
  • Good airflow
  • Widely visible nozzle
  • Completely separated from the fan. Allows working on toolhead without removing the fan. Or just print without cover for certain materials
  • Super lightweight 28g (3 spoons of peanut butter)
  • Atomic look
  • Easy swap to freshen up the look
  • Kept original magnets

How to print:

  • IMPORTANT: 0.16mm layer height. It has built in supports for the clips. They snap off nicely after the print is done. At 0.2mm layer height it will blend the support into the body.
  • Match with the highest temp material you're usually printing. PLA works with PLA just fine. For long term use, PETG/ASA/ABS is recommended though. 
  • Front side down.

Tagi