Zenker baking tray cover clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement clip for a plastic baking tray cover from Zenker.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 87
- Wydruki
- 1
- Wyświetlenia
- 301
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is easiest to print in its original orientation with supports for the clip legs. Unfortunately, in this orientation, the clip legs might be weaker and can break along the layer lines if pushed too much, e.g., when pulling the clip out of the case repeatedly. However, once the clip is fitted in place, the stress shouldn't be too great and the legs should hold well.
If you need the side legs to be stronger, you can also print it tilted or horizontally as shown below. Both of these orientations require a lot more support structures and post-processing.
The tilted variant seems to be a good compromise between supports, top surface finish and strength as the layer lines are oriented at ~45 degrees to the force acting on the legs.
The legs should be the strongest in the horizontal orientation, but the top surface doesn't look very nice and the print requires even more supports.
