1 / 3
Ball valve
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A working miniature of a ball valve. See the Build instructions down below, enjoy!
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 241
- Wydruki
- 3
- Wyświetlenia
- 1735
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 3) (Komentarze: 5)Remiksy (0)Kolekcje (66)Powiązane
Print all the parts as laid out in the STL's. Make sure your printer is well tuned because of all the threads. I used my prusa MK4 with a 0.4mm nozzle and a 0.15mm layer height and everything came together without any issues. Make sure that you use support when this is needed.
Build instructions
- Put the ‘ball’ in the ‘body’, the ball has a hole on one side. Make sure this hole is at the underside of the body.
- Screw in the ‘set bolt’ at the underside of the ‘body’, make sure the round top of the set bolt is the hole of the ball.
- Put the ‘seat’ in the ‘reducing ring’
- Screw the reducing ring and seat into the body
- Put the ‘bonnet bolt' into the ‘bonnet’
- Put the ‘stem’ into the ‘bonnet’, there is a 90 degree cut out in the bonnet where the stem needs to be in. This requires a little bit of force to put in.
- Put this subassembly on to the body, make sure the stem falls into the cutout of the ball.
- Tighten the bonnet bolt by using a flat head screw driver.
- Screw the flange into the reducing ring
- Screw in the reducing ring, flange and seat at the other side of the body.
- Screw the bonnet seal into the bonnet
- Screw one nut onto the stem put the handle on the first nut, now screw the second nut on top of the handle.
Enjoy!