Magnet insertion tool for 3mm, 4mm, 5mm, 6mm diameter magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As the title says
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 244
- Wydruki
- 1
- Wyświetlenia
- 1325
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Designed for inserting 3mm, 4mm, 5mm, and 5mm diameter magnets into printed projects.
Load a few magnets into the 10mm slot in the post in the desired orientation/polarity. These magnets hold the magnet on the tip in the desired polarity. Place some foam or tissue on the slot and then some cellophane tape to keep them in the slot.
Place a magnet to be inserted into the recess on the tip. It will only stick in the desired polarity.
Put a small amount of superglue in the magnet hole in your project, as needed.
Using this tool, align and start the magnet into the magnet hole in your project.
Remove this tool and press the magnet fully into the hole with a stick and wipe off any excess superglue.
Check the tool for any accumulated superglue and wipe off before it sets.
Print two of these in different colors and load them with magnets in opposite polarities.
To print, add supports under the post and tip area. This is a Fusion 360 parameterized design. On request, I'll post a .stl for other diameter magnets.
Did you build it? Please leave a comment and rating.
If you really love it you're welcome to throw me a bone. Thank you. :)