Troodon 2.0 Pro Printed XY Joint Lowers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sharp metal corners are bad.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Print with 10 walls and 90-95% infill for maximum strength. Highly recommend to print these slow and hot. ASA is fine, but I'd recommend ASA-GF or CF if you can.
These are printed lowers for the XY joints that replace the stock metal blocks to allow clearance for certain toolheads and fan ducts.
I switched to the Archetype Blackbird and couldn't home my toolhead due to the fan duct colliding with the sharp corner, so I redesigned the block to have a smooth corner that matches the curve of the upper half of the joint.
Fits together the same as the original, but you will need M3 /M4 hex nuts and M3 x 50mm / M4 x 50mm screws to be able to reach all the way in and tighten them fully.
Note - the hex nuts will not drop right into the holes in the bottom and will seem to not fit; when you insert the screws and begin to tighten them, the pull from the screws will begin to sink the nuts into the joint. They will be held in by friction and be incredibly rigid.