2x4 Lumber Brace for Sawhorse
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slide-on accessory for my plastic sawhorse that supports a 2x4, 2x6, or round lumber/wood on a single sawhorse
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I have a pair of plastic sawhorses that included these slide-on braces that allowed you to support a length of wood on a single sawhorse. A few went missing, and I couldn't find anything on the internet, either purchasable or printable, so I grabbed one of my remaining ones and got to measuring. About an hour later, this was drawn up in Fusion, and a couple test prints and adjustments were made.
I know Its kind of bespoke, not sure how many would get a use out of it. Included the Obj and F3d files if you need to customize it for your own needs. I did my test prints with minimal walls and surfaces, and 5% infill, but the final is printing with 5 walls and 20% infill for strength.