Wall Mount for 590S Mossberg with short shell bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall Mount compatible with 590S Mossberg with trigger safe release
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 452
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Wall mount for Mossberg 590S models with a factory installed short shell bumper. Added hole at bottom of mount body to facilitate a way to attach a trigger guard. Trigger guard releases when 590S is pulled from mount. I went for large mounting screws+ washer for a stronger attachment to wall (duct tape added to cover screw heads / avoid scratching the gun's finish). If using smaller screws that fit inside the recessed mount holes tape is not needed.
Printed in Carbon reinforced PLA, 100% infill, no support needed. Two pieces printed separately (otherwise it would take too long to print as a single piece as it would need support).
Two zip ties work OK for the trigger safe release, one attached to each side as shown in video
Qty 3 x M4 (4 mm diameter) 50 mm long bolts/washers/nuts to join the two parts
Suggest attaching to a wall stud, a #10 / ½” should fit through the mounting holes. Suggest using washers (5/8”) for better mechanical attachment (washer helps spread force through a wider area in the plastic part) .
The 2nd wall mount variation has larger countersinks (recess) to take large screw mounting heads/washers that do not protrude (prevents scratching the gun)
Pics are from the version with large countersinks