Wall Mount for 590S Mossberg with short shell bumper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wall Mount compatible with 590S Mossberg with trigger safe release
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 81
- Makes
- 0
- Views
- 452
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Share Alike
Wall mount for Mossberg 590S models with a factory installed short shell bumper. Added hole at bottom of mount body to facilitate a way to attach a trigger guard. Trigger guard releases when 590S is pulled from mount. I went for large mounting screws+ washer for a stronger attachment to wall (duct tape added to cover screw heads / avoid scratching the gun's finish). If using smaller screws that fit inside the recessed mount holes tape is not needed.
Printed in Carbon reinforced PLA, 100% infill, no support needed. Two pieces printed separately (otherwise it would take too long to print as a single piece as it would need support).
Two zip ties work OK for the trigger safe release, one attached to each side as shown in video
Qty 3 x M4 (4 mm diameter) 50 mm long bolts/washers/nuts to join the two parts
Suggest attaching to a wall stud, a #10 / ½” should fit through the mounting holes. Suggest using washers (5/8”) for better mechanical attachment (washer helps spread force through a wider area in the plastic part) .
The 2nd wall mount variation has larger countersinks (recess) to take large screw mounting heads/washers that do not protrude (prevents scratching the gun)
Pics are from the version with large countersinks