Wanhao Duplicator i3 (Monoprice Maker Select V2) electronics adapter plate/bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter plate for the Wanhao Duplicator i3 (Monoprice Maker Select V2) for mounting aftermarket electronics boards.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 149
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is an adapter plate for the Wanhao Duplicator i3 aka Monoprice Maker Select V2 for mounting aftermarket electronics boards.
This mounts in place of the stock Melzi Ardentissimo board and allows you to install:
- (1) E3 form factor 3D printer control board (e.g. BTT SKR Mini E3 (V2/V3), MKS Robin E3, Creality v4.2.7 board, etc.)
- (1) Raspberry Pi form factor SBC (e.g. Raspberry Pi 4, Pine64 Rock64, Orange Pi 5, Banana Pi M2, NanoPi M4, etc.)
- (1) LM2596 DC to DC buck converter (HW411)
- (1) Dual-Z axis breakout board
The USB port and SD card slot are not lined up with the factory holes. This is because there is no simple way to make both of them line up, and trying to line up just one would block the other. Since the USB is connected to the internal SBC and the SD card is often not used anyway I felt this wasn't much of an issue.
Note about LCD screens: You will probably need to replace your LCD screen. The factory LCD screen is not an “Ender-3 compatible” screen. There is (allegedly) a way to get the screen to work with other boards, but it will require custom wiring AND firmware.