1 / 6
Upcycled Small Parts Organizer - New Drawers and Inserts — zdjęcie 1
1 / 6

Upcycled Small Parts Organizer - New Drawers and Inserts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Make an old drawer organizer (more) useful again

Ocena
0 / 5
Polubienia
544
Pobrania
563
Wydruki
0
Wyświetlenia
9710
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

These small drawer organizers used to be very popular… but can be had for very cheap to free nowadays, especially if drawers are missing or broken.

I found this one with a bunch of drawers missing so decided to (re)make it better than it ever was.  These used to be very common and could be found in every garage and workshop and I believe the drawer size was also fairly standardized (at least for most of them).

A great bonus feature of this design is the inserts can be removed individually, at any time for access to parts.  As well as easily rearrangeable. 

The parts (drawers, handles and inserts) take a while to print but use very little material.
Recommended print settings:
PLA
Walls - 3
Top - 4
Bottom - 3
Infill - 20% cubic
Layer - 0.28 recommended for faster printing, but 0.2 will also work

Start with the Drawer and Drawer Pulls.  Then print the inserts you need as you need them.
I recommend filling out an entire drawer with inserts at one time so they don't slide or move around.

Glue the drawer pull to the (front) face of the drawer just below the label recess.  Use whatever glue works for you, but this is a great use case for PLA Gloop.

Double check an existing drawer to these dimensions.
Original drawer 139mm long x 54mm wide x 37mm deep (measured from the top/outside)

Like this build?  Buy me a coffee or beer with your tip using the links below.
Thanks :)
https://paypal.me/cdsmakestuff
or
https://www.venmo.com/u/cdsmakestuff

Tagi