Quest 2 Handstrap for Quest 3 Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to use the Quest 2 handstrap on the Quest 3. Should work with other straps, but this is not tested.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 50
- Wydruki
- 3
- Wyświetlenia
- 304
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial
I don't like the Quest 3 handstrap. And because my old Quest 2 is just lying around, i though why not use its instead. Nothing is sticking out and its strong enough. The slot for the cord might be a little tight, but since it works why change it?
It should work with other handstraps (like for the Wii) with < 1,35mm cord, but I have not tested it. Smaller cords will fit, but I think it would be better to make the slot smaller to have more material holding it.
Printed with 0,12mm layer height on my Bambulab P1S with Sunlu PLA+. If necessary, use a brim.