Thermostat for Filament Driers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bypass thermostat for longer filament drying times
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This thermostat will allow you to set your filament dryer box and it will stay warm without having to set it every 24 hours.
I love my filament driers, but having to set the time everyday is annoying. Most thermostats are large and bulky. And the small ones come without their own case. So I designed a small case around a $5 thermostat board.
Switch buttons install from the underside outward. Use Velcro to attach the thermostat case to your dryer box. If you wish to use this on a diy filament box, you can purchase small heaters on Amazon. If you wish to warm the box without a heater, use an AC computer fan. These are higher wattage and they will heat the box while moving a ton of air.
Thermostat board can be purchased here:
Working mode/setting temperature/return temperature setting:
1. In the running interface, short press the "set" key to enter the quick setting interface;
2. After entering the quick setting interface, short press the "set" key to switch the parameters you want to set (work mode/set temperature/return temperature);
3. Use the "up" "down" key to modify the parameter value, and they support short press/long press;
4. Press and hold the "set" button for more than 3 seconds or without any button operation for 6 seconds , it will save the parameters and automatically exit the quick setting interface.
- The XY-T01 electronic temperature controller range is -50 to 110°C, the high temperature control accuracy can reach 0.1°C, the sensor length can reach 0.5 meters.
- Heating mode ("H") and cooling mode ("C"), with high temperature alarm ("ALA"), delayed start ("OPH"), temperature correction function -10.0~10.0 °C ("OFE "), remote parameter reading/setting, real-time temperature report and other functions.
- The temperature control module is equipped with a 0.5-meter fine NTC probe, which is waterproof and not easy to rust, making the digital temperature control switch board durable.
- In the running interface, long press "set" for more than 3 seconds to enter the parameter setting interface;Temperature correction: -10 to 10Celsius, actual temperature = measuring temperature + calibration value