1 / 1
Garmin Varia mount for Canyon VCLS 2.0 seat post
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Garmin Varia rear light mount for the Canyon VCLS 2.0 seat post (Grail, Grizl, Endurace)
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 239
- Wydruki
- 0
- Wyświetlenia
- 1850
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (37)Powiązane
Minimalist Garmin Varia seat post mount for Canyon VCLS 2.0 seat post, which comes on some models of the Grail, Grizl or Endurace bikes
Ideally printed in ABS or another not-too-stiff material
Mounting requires either removal of the seat post and separation of the two carbon blades, or the removal of the saddle and saddle clamp.
Required hardware:
- 2x threaded heat set insert M3 x 5 x 4mm (Voron standard spec)
- 2x M3 countersunk head screw
Printing notes:
- Seat post clamp: no supports needed, print in the same orientation as it mounts to the bike. The thin wrap-around part needs to be printed in continous loops, else it will fail under load! This part requires tight tolerances on your printer, otherwise the two nearly touching ends may fuse - although it should be possible to separate them, e.g. with a chisel. Also, good bed adhesion is needed due to the small contact area.
- Quarter-turn mount: print flat on bed, the Varia-facing side facing up. Print with supports (on build plate only).