Z PROBE FOR HYPERCUBE (V2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is another simple autoleveling pasive mechanism for hypercube.These are parameters for Marlin config:Distance…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is another simple autoleveling pasive mechanism for hypercube.
These are parameters for Marlin config:
Distance from hotend: X = -41.5mm (41.5mm to left side) Y = 0
This thing was tested and is working fine. This is stronger than my before version.
Print Settings
Printer:
CORE XY
Rafts:
No
No
Resolution:
0,2mm
35%
Filament: --- PLA ---Post-Printing
ASSEMBLING:
You will have to use for assembling:
1 screw M3x50
2 nut M3
1 spring (14mm x 4mm). You can get it from a pen
1 magnet 9x2mm (Maybe you will need to add another one to increse the magnetic force)
1 microswitch 13x6mm
You will have to pass a drill of 3mm (and a little bit more) in order that the M3 screw pass through freely
The microswitch is connected in replacement of the original Z endstop
STEPS:
- Put the microswitch from top side. Glue it
- Assemble screw-nut-TOPE SENSOR-nut
- Put the magnet from the side to the pocket
- Calibrate the spring force, stretching it if necessary for activating the microswitch when the screw is down, and touching the magnet when the screw is up.
- Mount the assemble in the carriage.
Category: 3D Printer Parts