1 / 7
Filament Drybox
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Single 1kg spool simple passive drybox
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 893
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (17)Powiązane
This simple drybox is made of a cereal container and uses silica gel beads to dry filament to about 20-30% humidity.
Specific Parts (If in Australia)
- Hygrometer (moisture sensor) https://www.amazon.com.au/dp/B0C9SZQMSD
- Cereal container https://www.bigw.com.au/product/brilliant-basics-clip-lock-cereal-container-3-8l/p/248444
- [edit] Screws https://www.amazon.com.au/dp/B08ZCKS41F
Additional Parts
- 10mm diameter rod (Mine is aluminium)
- Roughly 100-200mm section of bowden tube
- Bowden tube passthrough sharkbite fitting
- 18x ST2.2x13 (26x13mm) screws
- Silica gel beads
- Glue/silicon for sealing cereal lid dispenser
Assembly Notes
- Most mounts have an inner and outer component for scews to screw into
- Position the spool inside your chosen container and mark where the spool rod mounts should be
- Once spool rod mounts are installed and parallel, cut the rod to width and slip both spool roller over top - this design does not use bearings, as there should be minimal friction between metal and plastic
- Drill hole size of outer diameter of bowden tube and install sharkbite mount
- Hygrometer can be installed in flip lid section once lid has been sealed with silicon/glue
- Fill box with gel beads and attatch lid and drop inside