Rocket launch pad for rockets like estes and klima rockets 3-6mm rods

Hi. This Is a work in progress but very close to perfect.  I have tested all the parts. All parts fit from a little filing to filing all the overprinted corners of the center part as my printer make big corners that has to be filed off before fitting legs. this is different from any printers and therefore i dont compensate this in the file. this overprinted corners is quick to file off with a flat file.

The legs is designed to be fitted on the flying site for easy carrying. but the middle part of the legs should be glued together for a stronger part.

The center part is made to fit with a 6mm bolt with a wing nut on the other side so you can easely change the angle of launch for the rocket

The plate under the rocket i made with 1.2mm thick steel plate witch i cut out with a hole saw with diameter 150mm. it has a 10mm hole in the center and 7mm holes on each side to fit and lock plate holder to the steel plate

Disclaimer: This is made for 3 and 6 mm rods. with 6 mm rods this rocket ramp may be to light so please make sure your rocket isnt to big for this rocket ramp. smaller rocket with 6 mm rod may be fine. but please be sure before you launch.

Print settings

I have printed  with creality ender 3 v2

Recommended minimum print bed size 220x220mm

Printed with esun PLA+ 

4 layers on top, bottom, and sides.
30 % infill
support on
0.28 layer hight

This is what i used and will work fine for smaller rockets.
But if you want it stronger feel free to change that. but the minimum is what i used