Tonor G11 mic wallmount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tonor G11 mic mount
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Public Domain
I am apart of a club that has this microphone attached currently to the ceiling with pushpins and rubber-bands so I needed something to hold it better. This is just a quick 20 min build. I tool the mic and measured and made something to hold it. When printed I did use supports just for the clean look. I also printed as a prototype without and no physical issues just cosmetic. I did make it a few mm bigger because mine was tight. Also included is the .obj. I made it in Tinker Cad. I also used blank squares to reduce the amount of material when printed. Worked well. Holds it tight and a better solution than when I started.